consultla.blogg.se - 2005 ford f150 lariat fuel pump module

Run/Start feed - Flasher relay (2004), Electrochromatic mirror, Heated seats, BSM, Compass, RSS (Reverse Sensing System), Power rail (2008), Run/Start feed - Overhead power point (2005-2007)Ģ005-2007: Battery feed for overhead power pointĭelayed accessory power for audio, power door lock switch and moonroof switch illuminationīattery saver power for demand lamps, Flex fuel (2008)

Overdrive cancel, Cluster, Brake-Shift Interlock (BSI (2004))ĪBS module (Run/Start power (2004)), Brake-shift interlock solenoid (2005-2008) Trailer tow back-up lamps relay, Trailer tow parklamp relayĬlimate control module power, Flasher relay (2005-2008)īack-up lamp and Daytime Running Lamps (DRL) relay coil, A/C pressure switch, Brake-shift interlock solenoid (2004), Heated PCV (5.4L), ABS (2005-2008), Trailer tow back-up lamps relay coil (2005-2007), Reverse park aid (2005-2007), EC mirror (2005-2007), Navigation radio (2007), Redundant speed control switch (2005-2008) Parklamps, Body Security Module (BSM), Instrument panel illuminationĢ006-2008: Fuel pump relay, Fuel injectors, Injector sense, Intake manifold runner control (4.2L)

Keep alive memory for Powertrain Control Module (PCM) and climate control module Stop/Turn lamps, Brake on/off switch, Hazard flashers (2007), T/T electric brake module (2008), PCM (BOO signal (2008)), turn signal mirrors (2008), CHMSL (2008)Ģ004-2005: Power mirrors, Memory logic power (2004), Memory seats and pedalsĢ006-2008: Power mirrors, Memory seats and pedals, Driver power seat (2007)ĭVD battery power, Power fold mirror (2005-2008) Run/Accessory - Wipers, Instrument cluster, Audio (2005-2008 - XL/STX) Gently pull on the cover to make sure it is seated properly. To reinstall the fuse box cover, place the top part of the cover on the fuse panel, then push the bottom part of the cover until you hear it click shut. To remove the fuse box cover, place a finger behind the PULL tab and your thumb above the PULL tab as shown in the illustration, then pull the cover off. Remove the trim panel and fuse box cover to access the fuses. The power distribution box is located under the right-hand side of the instrument panel.

If a fuse blows again contact a qualified service center.

Use always an intact fuse of the same color.

Never replace a broken fuse with anything other than a new fuse.

Using a fuse with a higher amperage rating can cause severe wire damage and could start a fire.

Always replace a fuse with one that has the specified amperage rating.

Always disconnect the battery before servicing high current fuses.

Before replacing fuses check that the key has been removed from the ignition and that all the services are switched off and/or disengaged.